Downspouts that are emptying too close to the building.
Gutter too close to house.
Leave the old spikes in place a spike head looks better than a hole in the gutter.
Gutters should be hung where a straight edge laying on your roof shingles can easily extend over the front lip of the gutter this is the proper installment location for the high point of the gutter.
Also downspouts or leaders that have been disconnected or were improperly connected.
For gutters to work properly they must be properly sloped toward the downspouts and the roof must have a drip edge that clears the sides of the gutters closest to the house.
Gutters hung too high or too low.
Gutter extensions attached to the bottom of the downspout will discharge water well beyond the foundation.
If you re installing downspouts on your gutter system be sure that they extend several feet from your home.
Attach elbow to bottom end of downspout and connect a downspout extension to carry rainwater away from the foundation.
Gutters that are too high can enable runoff water to drip down their back side which in turn can cause deteriorating fascia boards and stains on siding.
One way to make sure your gutters don t fall off the house is to install fascia hanger brackets.
One way to make sure your gutter doesn t fall off the house is to install fascia hanger brackets.
Just hook the bracket under the front lip of the gutter and then screw the other side of the bracket to the fascia.
If yours are nonexistent in poor condition or improperly placed on your house they could be causing problems and putting your home at risk of water damage.
The guttering should run a few inches lower than your roofline.
Also gutters that are falling off improperly sloped or leaky discussed here at gutter defects list downspout defects.
If downspouts drain too close to the home this can also result in pooling water around the home.
Otherwise they ll dump water right into your basement or pool on the ground beside the foundation.
Clean gutters regularly to keep rainwater flowing freely.
Just hook the bracket under the front lip of the gutter and then screw the other side of the bracket to the fascia.
They re inexpensive and easy to install.
Leave the old spikes in place a spike head looks better than a hole in the gutter.
When water drips between the fascia and the gutters the problem could be a compromised drip edge but it s also possible the gutters are overflowing.